articles

Advantage: Follow Ability

#1  
Problem Poor Follow Ability.
Solution
  1. ART Secondary Flow may be too low (phaco only).
  2. Verify the settings in general, higher Flow Rate may be needed.
  3. Check that phaco hand piece is working correctly.
  4. Make sure Cobra sleeve is not worn allowing too much irrigation out the front of the sleeve.
  5. Check that the incision size is not too large and allowing too much fluid to leak out the incision.

Back to top

©2018 Surgical Design Corporation. All Rights Reserved.  12/14/18
Website Design and Development by Timothy Wood Design, LLC